Carrier INFINITY KIT63000 - Manual (Page 2)

1: Turn off power to the heating and cooling system and to the Infinity TM air
purifier.
2: Remove the air purifier door (Fig. 1). Disconnect the power cord and air
flow sensor cables from the power supply module (Fig. 2).
3: Remove the filter and enhancement module from the air purifier cabinet
(Fig. 3) and place on a flat surface in a well lit area.
ELECTRICAL SHOCK & HIGH VOLTAGE
HAZARD
Failure to follow this warning could result in
personal injury or death.
Before installing or servicing system, always turn
off main power to system. There may be more
than one (1) disconnect switch.
WARNING
REMOVING THE OLD POWER SUPPLY:
CUT HAZARD
Failure to follow this caution may result in personal
injury. Sheet metal parts may have sharp edges or
burrs. Use care and wear appropriate protective
clothing and gloves when handling parts.
CAUTION
Fig. 1
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
TO POWER SUPPLY
TO ENHANCEMENT GRID
4: Disconnect the green ground wire from the
enhancement module (Fig. 4).
5: Cut the two high voltage wires where they
exit the power supply enclosure (Fig. 5).
6: Disconnect the ¼” quick disconnect terminal (with the cut wire)
from the ionization array and discard (Fig. 6) - this may require
the use of needle-nose pliers.
7: Cut the splice away from the media enhancement grid wire (Fig. 7).
Cut the media enhancement grid wire next to the wire splice under
the heat shrink tubing (Fig. 8).
Fig. 2