Warning, Pre-starting, Instructions – Troy-Bilt 13027 User Manual

Page 18: Figure 4-1, Pre-starting instructions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Section

Steering Wheel

Brake Pedal

Choke Lever / //) Fuel

Cap

Throttle Lever

Light
Switch

Cruise Control
Switch (Optional)

Figure 4-1

Hour Meter (Optional)

Keyswitch

Electric Lift
(Optional)

Choke ■ FTO Indicator volt Light

Leygj

Light

^

Light

Indicator Light

Lever

WARNING

Before operating your tractor,
be sure you read and under­
stand all safety, controls, and
operation instructions in this
Owner/Operator Manual and
on the decals on your tractor.

Failure to follow these in­

structions can result in seri­
ous personal injury or prop­
erty damage.

PRE-STARTING
INSTRUCTIONS

Please read and carry out the

following pre-starting instructions
and procedures before starting the
tractor engine and using your
equipment.

1. Be sure the engine has been

filled with the proper type and
amount of motor oil. Check the
oil level by removing the engine
dipstick on top of the engine (see
Assembly Step 8 in Section 2).

2. Check for any oil or fluid leaks
on the tractor or on the ground.

18

Any leaks must be attended to be­
fore starting your equipment. See
your Authorized Dealer for assis­
tance if needed.

3. Check the battery electrolyte
level. Fill any cells that are below
the full mark with distilled water.

4. Fill the fuel tank with fresh,
clean unleaded gasoline. Auto-
motive-grade Unleaded Regular
gasoline with an octane rating of

87 minimum is highly recom­
mended. Clean up any spills. DO
NOT MIX MOTOR OIL WITH

THE GASOLINE!

Advertising
This manual is related to the following products: