MTD 243-685-000 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hand
Knob
Cupped
.Washer
Cupped
Was her
Thumb
Screw
ATTACHING THE AIR DUCT ASSEMBLY
(Hardware A)
Place air duct assembly over opening on top of hous
ing. Secure front of air duct assembly with one flat
washer, cupped washer (cupped side of washer
against flat washer) and a hand knob. Secure back
(close to engine) with one cupped washer (cupped
side against air duct assembly) and thumb screw. See
-figure 6.
FIGURE 6.
INSTALLING THE BAG (Hardware C)
1.----Place the stud pins in holes in upper handle
(head of pins go to the inside of handle). Secure
pins with push-on speed nuts by holding speed
nut with box wrench and tapping pin with ham-
----- mer. See figure 7.
FIGURE 7.
Stud Pin
On Handle
2. Assemble the bag by slipping the top straps on
bag over upper handle. Hook two small straps
over stud pins on handle. Slip elastic opening of
bag over air duct assembly. Be certain elastic on
bag is placed over the flanges on air duct assem-
— bly. See figure 8.
FIGURE 8.