Husqvarna U03380 Built-in Oven - Manual (Page 3)

Electrical connection
WARNING
- THIS APPLIANCE MUST BE
EARTHED
Your Husqvarna cooking appliance must be
connected to a double pole main switch, situated
in close proximity to the appliance, by a qualified
electrician.
Ensure that the voltage marked on the rating
plate situated on the rear of the cooker
corresponds to your mains supply voltage.
ELECTRICAL CONNECTION, DUO OVEN
Fitting of Doors
® @ ®
NEUTRAL LIVE AUTO-TIMER EARTH
CONNECTION
The'thermostatic hotplate on the Reginett
electric top and the rear right-hand heating zone
of the Ceramic hob can be auto-timed by the Duo
Oven.
Disconnect the link between terminal 4 and 5
on the hobs and then connect terminal 5 to
terminal 4 on the Duo Oven.
2 3 4 5 Firstly ensure that the hinge hooks are in the
upright position on all four hinges. If this is not the
case pull the hinge forward until the hook is
exposed and lift the hook up then allow the hinge
to return into the oven body until the hook grips.
Then place the door sqilarely onto the hinges,
open the door to its fullest extent, push the hooks
back into position and close the door.
Description
1. Auto-timer
2. Indicator Lamps
3. Upper Oven Element Control
4. Upper Oven Thermostat
5. Lower Oven Control
6. Air Outlet Ventilation Grill
7. Upper Oven
8. Lower Oven
9. Air inlet Ventilation Grill
10. Door Safety Catch
Using the oven for
the first time
NOTE: Before using the oven for the first time
both ovens should be burned in. Ensure that all
cardboard packing etc., is removed from both
ovens before switching on the electrical supply.
Set both ovens on their highest setting for
approx. 30 minutes making sure that the kitchen
is thoroughly ventilated as a certain amount of
smoke can develop.