Troy-Bilt 12065 - Manual (Page 32)

Tlïier & ERglne Spec . , ' 3
TILLER ENGINE
Height
Without Handlebars .....................................21!4"
With Handlebars in lowest position..............37X”
With Handlebars in highest position ........... 46!4"
Length
With Handlebars in lowest position............. 53!4"
Without Handlebars .................................... 36%”
Width
Hood Width ..................................................15K"
Tilling Width....................................................14-
Wheel Width ......................................13J^"-14X"
Width at top of Handlebars..............................18"
Weight (w/o oil or gas)......................... 117 pounds
Transmission Gear Oil Specifications
Small Top-Offs: SAE 140, SAE 85W-140, or
SAE 80W-90 weight gear oil with an API
rating of either GL-3 or GL-5.
Full Replacement: SAE 140 or SAE 85W-140
weight gear oil with an API rating of GL-3 only.
Engine Type
Tecumseh 3 Horsepower, single cylinder
air cooled, horizontal crankshaft, with manual
choke and solid state ignition.
Fuel Tank Capacity
2 Quarts.
Fuel Specifications
Unleaded regular gasoline. See Engine Owner’s
Manual for other gasoline recommendations.
DO NOT use Leaded gasoline.
Engine Oil Capacity
Approximately 21 ounces (L4 pints).
Important: Always be sure the oil level is at
the point of overflowing from the oil filler tube.
Spark Plug
See your Engine Owner’s Manual for the
recommended spark plug type.
Spark Plug Gap
.030"
Ignition System
Solid State Electronic Ignition
(no points or condenser required).
32