To replace mower drive belt (see fig. 23), Service and adjustments – Husqvarna 917.27909 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
TO REPLACE MOWER DRIVE BELT
(See Fig. 23)
MOWER DRIVE BELT REMOVAL
•
Park tractor on a level surface. Engage parking
brake.
•
Lower attachment lift lever to its lowest position.
•
Disengage belt tension rod from lock bracket.
A
CAUTION: Belt tension rod is spring
loaded. Have a firm grip on rod and
release slowly.
Remove screws from R.H. and L.H. mandrel covers
and remove covers.
Remove any dirt or grass clippings which may have
accumulated around mandrels and entire upper deck
surface.
Remove belt from electric clutch pulley, both mandrel
pulleys and all idler pulleys.
MOWER DRIVE BELT INSTALLATION
•
Install belt around both mandrel pulleys and around
idler pulleys as shown.
•
Install belt onto electric clutch pulley.
IMPORTANT:
CHECK BELT FOR PROPER ROUTING IN ALL
MOWER PULLEY GROOVES.
•
Reassemble R.H. and L.H. mandrel covers. Securely
tighten all screws.
•
Engage belt tension rod on locking bracket.
CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and
engage slowly.
Raise attachment lift lever to highest position.
22