Sfbvirf and, To remove mower (see fig, 20), To install mower (see fig. 20) – Poulan 157257 User Manual
Page 19: To levl. mower housing, Traci nr^ to remove mower (see fig, 20)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S F B V i r F A N D
in
3 ANY S
lly and s
IBLitrsi (f
ISENGA
smove to
rHVICE C
it parkiric
I) positior
3FD”
I.DJUSTMEN1
iltion
r, j . I , <o'qri ' f
V i!m -Ip,
i 4
t
».¿.ex*,- Ci^
TRACI nr^
TO REMOVE MOWER (See Fig, 20)
Mower will be easier to remove from the right side of tractor.
» Place attachment clutch In “DISENGAGED” position.
•
Move attachment lift lever forward to lower mower to its
lowest position.
•
Roil belt off engine pulley.
•
Disconnect dutch rod from clutch lever by removing
retainer spring.
« Disconnect anti-sway bar from chassis bracket by
removing retainer spring.
•
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
•
Disconnect front links from deck by removing retainer
springs.
« Raise lift lever to raise suspension arms. Slide mower
out from under tractor,
IMPORTANT: IF
AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS,
TO INSTALL MOWER (See Fig. 20)
•
Raise attachment lift lever to Its highest position,
•
Slide mower undertractorwith discharge guard to right
side of tractor.
•
Lower lift lever to its lowest position.
•
Install mower in reverse order of removal instructions.
FIG. 20
arts have completely stopped.
plug and place wire where it cannot come in contact
TO LEVL. MOWER HOUSING
Adjust the mower while tractor is parked on level ground or
drivesi/ay. Make sure tires are prcoerly inflated (See
“PRODUCT SPECIFICATIONS” on paged of this manual).
If tires are ever or undennfinted, you wtl not properly adjust
your mower.
SIDE-TO-SIDE ADJUSTMENT (See Figs. 21 and 22)
•
Raise mower to its highest position.
•
At the midpoint of both sides of mower, measure height
from bottom edge of mowerto ground. Distance ”A” on
both sides of mower should be the same or within
of each other.
•
If adjustment is necessary, make adjustment on one
side of mower only.
•
To raise one side of mower, tighten lift link adjustment
nut on that side.
•
To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE; Three full turns of adjustment nut will change
mower height about 1/8",
• Recheck measurements after adjusting.
BOTTOM
EDGE
OF
MOWER TO
GROUND
BOTTOM
EDGE
OF
MOWER TO
GROUND/
GROUND
l i n e
-
fig
. 21
19