MTD 24604C - Manual (Page 4)

NOTE
This unit is shipped WITHOUT GAS­
OLINE or OIL. After assembly, see
operating section of this manual for
proper fuel and engine oil recom­
mendations.
Q
J
ASSEMBLY INSTRUCTIONS
FIGURE 1
HOLE AND SLOT
IN FRAME
FIGURE 2
LOCK WASHER (G)
SHOULDE \
BOLT (F)
NOTE
Any reference to right and left hand
will be determined from behind the
edger, in the operator's position.
TOOLS REQUIRED:
A (1) Adjustable Wrench.
B (1) 7/16" Open End or Box Wrench.
n
(1) 9/16" Open End or Box Wrench.
D (1) Pair of Pliers.
E (1) Hammer
F (1) Block of Wood.
CONTENTS OF HARDWARE PACK:
(See Figure 1)
A (2) Hair Pin Cotters
B (1) Rod Adjustment Link
C (2) Cotter Pins 1/8" Dia. x 1.00" Long
D (1) Spacer .50" I.D. x .62" O.D. x 1.62" Long
E (2) Push Caps
F (2) Shoulder Bolts (Rear Axles)
G (2) Lock Washers 3/8" I.D.
H (2) Hex Nuts 3/8-16 Thread
1 (2) Cable Ties
J (4) Carriage Bolts 1/4-20 x 1.25" Long
K (4) Lock Washers 1/4" I.D.
L (4) Hex Nuts 1/4-20 Thread
M (1) Hex Bolt 5/16-18 X 1.75" Long
N (1) Compression Spring
0 (1) Flat Washer
P (1) Hex Center Lock Nut 5/16-18 Thread
Q (2) Hex Bolts 1/4-20 x 1.25" Long
R (4) Hex Center Lock Nuts 1/4-20 Thread
S (2) Hex Bolts 1/4-20 X 1.00" Long
T (3) Grips
u (1) Self-Tapping Screw
1. Remove the edger and all parts from the carton.
2 .
Make certain that all loose parts and literature
are removed from carton before carton is dis­
carded.
Line up holes in lower handle with holes in
frame. Secure rear wheels (larger) and lower
handle to frame with shoulder bolts (F), lock
washers (G) and hex nuts (H). See figure 2.
3. Using a hammer, tap one push cap (E) onto the
end of the front axle which has a hole closer to it.
See figure 3.