Poulan 169087 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
s i F M V » r F A l v i f ;
I'
< L -/i L •■i'', ¿liELl liC*^ S -'ir-r.
Adiust the mower while tractor is oarkec
uUC
■If
>PtCIHo-Ai lijNW seciion oi mis mare...........,
If tires are over or underinfiated, you will not properly
adjust your mower.
I
‘
! '
' “
’
' ' '
>
If I
H or ft iw r i'i ii‘ n af - I h >
' >i
A> t i .nidf'-'i.'i H h ih
‘J H> wc i, ntWjjUi.
im pni tr< tT! tcj'cm <-cu«r <■ -nvAei ;o uounJ
[t h,r ' /' U, d I'l t -its .| n UWi I litulobeiii-
.. ill c • I witliiii I/4‘ (4 etch oihet.
!i Jr
1^ n' I n CO* sary make adjustment on one
bi'!^ i! r ■(
1
»'i-r' iiL'
f
1.1 ii - ».a ,P - ,)i mt iv^-r lighten lift link adjusirnenf
iit)i OP mat ~!ic
•
lo lower one siae or mower, loosen lift link adjust
ment nut on that side.
NOTE: Three full turns of adjustment nut will change
mower height about 1/8".
•
Recheck measurements after adjusting.
BOTTOM EDGE
OF MOWER TO
GROUND
BOTTOM EDGE
OF MOWER TO
GROUND
GROUND LINE
FIG. 19
FRONT-TO-BACK ADJUSTMENT (See Figs. 20 and 21)
IMPORTAMT; DECK MUST BE LEVEL SIDE-TO-SIDE. IF
THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NEC
ESSARY, BE SURE TO ADJUST BOTH FRONT LINKS
EQUALLY SO MOWER VJILL STAY LEVEL SIDE-TO-SIDE.
!
? Mil 'h-
t.- I ' I'lMC .
!| Ih- n"
• •'
'll.}
Should be adjusted so that the front is approximately 1/8"'
to 1 / 2 " lower than the rear when the mower is in its high-
* I I j-Hlor
C’n*-Lt aulu' iui-rC '■I! i.qhi j< € rf tocto. HeE'Him tir-
iinm D iirerny ,r, front ard oM. (id ihf maiJi-l jt Of t-
u.rr. criM*- of Piowpr riot sii,q 'njw'i
*
Before mar ng an,f t'er‘'s:?ry c.Jjustments check
that bofn front Ini-i ore equal lo Icngtn Both link-
■r ould t‘( spDrr.,.rn3toiY i l - i / 8
*
If I'nW are no! equal in length .^d|Ubt ine lint io .^ame
length dS )thei link
*
To lower front of mower loosen nut “E” on both front
links an equal number of turns.
•
When distance “D” is 1/8" to 1/2" lower at front than
rear, tighten nuts “F” against trunnion on both front
links.
•
To raise front of mower, loosen nut “F” from trunnion
on both front links. Tighten nut “E” on both front links
an equal number of turns.
•
When distance “D” is 1/8" to 1/2“ lower at front than
rear, tighten nut “F” against trunnion on both front
links.
•
Recheck side-to-side adjustment.
■ ' i h