C. handle assembly, B. depth bar, D. control assembly – MTD 1850 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 1-1. WHEEL ASSEMBLY
Refer to Figure 1-2.
Step 3. Place the wheel hanger into the tailpiece and
secure with clevis pin D and locking pin E.
c. Handle Assembly
Refer to Figure 1-3.
Assemble the handle to the handle bracket with 4
hex bolts G, lockwashers I and hex nuts H.
FIGURE 1-3 HANDLE ASSEMBLY
b.
Depth Bar
Refer to Figure 1-2.
Step 1. Attach the depth bar to the tailpiece with the
clevis pin.
Step 2. Secure the clevis pin F with the locking pin E.
d. Control Assembly
Refer to Figure 1-4.
Step
1.
Place
the
control
lever
through
the
handle
assembly.
Step 2. Attach at the bottom with hex bolt J, steel
washer K, rubber washer L and secure with
hex nut M.
FIGURE 1-2. WHEEL HANGER AND DEPTH BAR