NordicTrack EXP2000 NTTL11994 - Manual (Page 10)

A CAUTION:
Before operating the
console, read the following precautions.
^ Do not stand on the walking belt when turn­
ing on the power. ^ ^ ^ ^ ^
• Always wear the clip (see the drawing below)
while operating the treadmill.
• Adjust the speed in small Increments to
avoid sudden Jumps in speed.
• The pulse sensor is not a medical device.
Various factors may affect the accuracy of
heart rate readings. The pulse sensor is in­
tended only as an exercise aid in determin­
ing heart rate trends in general.
• If you have heart problems, or if you are over
60 years of age and have been inactive, do
not use the pulse-driven program. If you are
taking medication regularly, consult your
physician to find whether the medication will
affect your exercise hart rate.
• Using hand weights and not holding the
handrails may compromise your ability to
maintain your balance. Hand weights should
be used only by experienced users.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and place only a sealed water
bottle in the water bottle holder. ...................................
GETTING STARTED
Attach the clip to the waistband of your clothes.
JilAkl j|||| AlUJ-'
IQL
Clip
Stand on the foot rails
of the treadmill. Find
the clip attached to the
key and slide the clip
onto the waistband of
your clothes. Next, in­
sert the key into the
console.
Test the clip by carefully taking a few
steps backward until the key is pulled from the
console. If the key is not pulled from the con­
sole, adjust the position of the clip as needed.
Then, remove the key from the console.
Plug in the power cord.
See HOW TO PLUG IN THE POWER CORD on
page 8.
Move the on/off switch to the on position.
Locate the on/off switch
on the treadmill near the
power cord. Move the
on/off switch to the on
position.
Insert the key fully into the console.
Stand on the foot rails of the treadmill. Make sure
that the clip is securely attached to the waistband
of your clothes. Next, insert the key into the con­
sole. After a moment, various displays and indica­
tors on the console will light. Note: When the key
is inserted, the treadmill incline system may auto­
matically calibrate itself—the treadmill will rise to
the highest incline level and then return to the low­
est incline level.
■3 Enter your weight.
Although you can use
the console without
entering your weight, the
console will count the
calories you burn more
accurately if you enter
your weight. To enter your weight, press either of
the Enter Weight buttons. The current weight set­
ting will appear in the Speed/Pace display. Press
the Enter Weight buttons again to enter your
weight. Four seconds after the buttons are
pressed, the weight setting will disappear from the
display. Your weight will then be saved in memory.
To use the manual mode of the console, follow the
steps beginning on page 11 , To use a preset program,
see page 12. To create and use a custom program,
see pages 14 and 15. To use the fitness test program,
see page 16. To use the pulse-driven program, see
page 17. To use an iFIT.com CD or video program,
refer to page 21, To use an iFIT.com program di­
rectly from our internet site, see page 23,
10