Important – MTD 216-406-000 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Wheel Chain
Wheel Chain.
Case Pulley Forward
Drive Belt
Forward
Engine Pulley //
FIGURE 25.
4. To remove the forward drive belt, proceed as
follows.
A. Loosen (do not remove) the hex nut at the top
of the wire belt keeper.
B. Pull bottom of wire belt keeper out and then up
ward, pivoting it away from the forward engine
pulley. See figure 24.
5. Reassemble new belts, following instructions in
reverse order.
IMPORTANT
When reassembling belts, be certain
belts
are
routed
around
all
belt
keeper pins as shown in figure 26.
Tine Belt
FIGURE 26.
Forward
Drive Belt
Belt Keeper
Pins
Belt Keeper
Pins
C. Lift belt off the forward engine pulley. See figure
25.
D. Remove belt from inside sheave of wheel chain
case pulley.
NOTE
Upon reassembly, refer to illustra
tion on page 18 for correct assembly
of wire belt guard for your model
tiller.
13