Troy-Bilt TUFFY 645A User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 2-3: Wheel in FREEWHEEL position
(wheel drive pin through wheel shaft only).
STEP 4: INSTALL FORWARD
CLUTCH CABLE
1. Carefully unwrap the forward clutch ca
ble (cable without an attached knob) from
Its shipping position and slide the thin ca
ble wire (M, Fig. 2-4) into the slot in the ca
ble bracket. Push the cable connector (N,
Fig. 2-4) up through the hole in the bracket
until the groove In the connector snaps
into place.
2.
Thread the #10-24 hex nut (Z, Fig. 2-5)
halfway onto the screw (V) which runs
through the spring (W, Fig. 2-5).
3.
Thread the screw (V) Into the cable ad
juster (X).
through the wheel shaft (L) only (not
through the wheel hub). The wheel should
now spin freely (freewheel) on the wheel
shaft. Repeat with the other wheel.
4.
Use the handlebar to roll the tiller to a
flat area.
IMPORTANT:
Before starting the engine,
the wheels must be placed in the WHEEL
DRIVE position (pins through wheel hubs
and wheel shaft). This procedure is
described in
Wheel Drive Pins
on page 10.