Mr. Coffee TM3 SERIES - Manual (Page 9)

To Brew Iced Coffee
Follow the instructions for iced tea using the suggested amount of coffee in the
chart listed on Page 7.
C aution : Decaffeinated coffee, particularly when used with chemically
softened water, can cause slower filtration.
Daily Care
To maintain the quality of all parts and minimize tea stains, we recommend
washing the pitcher, pitcher lid, steeping basket and lid with warm water
and a mild detergent, regularly. T hese I tems A re NOT D ishwasher S afe .
Hard water can leave whitish mineral deposits inside the pitcher and steeping
basket. Tea and coffee discolor these deposits. To remove, fill the basket
and pitcher with warm white vinegar and let It soak for about 20 minutes.
Do not use harsh, abrasive cleaners. They will cause scratches which
can lead to breakage.
Deliming
This unit must be delimed when you begin to notice an increase in steaming
or if the pumping action stops before all the water has been pumped out of
the machine.
The frequency of cleaning depends on the hardness of water used.
Listed below are the suggested cleaning intervals.
SUGGESTED Type of Water Cleaning Frequency
CLEANING Soft Vtfater Every 80 Brew Cycles
INTERVAL Hard Water Every 40 Brew Cycles
This iced teamaker may be delimed using vinegar or MR. C®FFEE® C leaner .
MR. C®FFEE® C leaner may be purchased at your local retailer or by
writing or calling the Consumer Service Department listed on Page 3.
Using MR. C®FFEE® C leaner :
(Read caution statement on side panel of MR. C9FFEE^ C leaner box before use.)
1. Fill pitcher with warm water to the water level marked on the pitcher
(36 ounces of warm water).
2. Empty contents of one packet of MR. C®FFEE® C leaner into pitcher.
Mix thoroughly to dissolve cleaner. This will make a clear blue solution.
3. Pour entire contents of pitcher into the water reservoir of the iced teamaker.
4. Place one tray of Ice cubes in the pitcher.
5. Place steeping basket, with lid, into the pitcher and slide the pitcher
under the machine. The pitcher must be placed snug against the
machine before operation.