MTD 24596-8 - Manual (Page 9)

FIGURE 15
7. Set edger back on its wheels. Replace spark plug
wire.
OFF-SEASON STORAGE
The following steps should be taken to prepare unit
for storage.
1. Clean and lubricate unit thoroughly.
2. Refer to engine manual for correct engine storage
instructions.
3. Coat unit's cutting blade with chassis grease to
prevent rusting.
4. Store unit in a dry, clean area.
NOTE
When storing any type of power
equipment in an unventilated or metal
storage shed, care should be taken to
rustproof the equipment. Using a
light oil or silicone, coat the equip­
ment, especially springs and bearings.
TROUBLE SHOOTING CHART
PROBLEM CAUSE REMEDY
1. Engine fails A. Check fuel tank for gas. A. Fill tank if empty.
to start.
B. Spark plug lead wire
disconnected.
B. Connect lead wire.
C. Faulty spark plug. C. Clean, adjust gap or replace.
2. Hard starting A. Spark plug wire loose. A. Connect and tighten spark plug wire.
or loss of power.
B. Dirty air cleaner. B. Clean air cleaner as described in engine manual.
3. Engine over­
heats. A. Carburetor not adjusted
properly.
A. Adjust carburetor. See engine manual.
B. Air flow restricted. B. Remove blower housing on engine and clean as described in the
engine manual.
C. Engine oil level low. C. Fill crankcase with the proper oil.
4. Excessive
vibration at
blade.
A. Spindle bolt bent.
B. Ball bearing worn out.
A. Replace spindle belt.
B. Replace ball bearing.
Belt slips. A. Belt worn or stretched. A. Replace belt.
L___
B. Clutch handle will not
remain in clutch plate.
B. Readjust spring tension at clutch handle.
NOTE: For repairs beyond the minor adjustments listed above, please contact your local service dealer.