MTD 248-685-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
1. Place nozzle (N) in position on front of housing
so that it rests in flanges. Secure with one hand
knob (F) and beileville washer (G). See figure 4.
NOZZLE (N)
FIGURE 4
UPPER
HANDLE (O)
2. Place the upper handle (0) in position over lower
handle. Fasten with four hex bolts (I) and lock
nuts (J) provided. See figure 5. Two 7/16"
wrenches are required.
FIGURE 5
3. Place the stud pins (K) in holes in upper handle
(head of pins go to the inside of handle). Secure
pins with push-on speed nuts (L) by holding
speed nut with box wrench and tapping pin with
hammer. See figure
6
.
Advertising
This manual is related to the following products: