Poulan 169482 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
<s I
. fi/j)
i j i f M , ' ■;|li
Adjust
the
mower
while
tractor is parked on le¥el
ground or
driveway.
Make
sure tires are properly inflated
(See
“PRODUCT SPECIFICATIONS" on page 3 of this manual).
If
tires
are over or
underinflated, you
will not
properly adjust
FRON
J-BA
OJUS
)U
mwer.
j|i4 “IO-biL'^ Ji M. II ipo. i3c;ru30j
•
Raise mow/er
to its highest position.
^ Atihemidpoi.Huf
buiii
aiutaoi
mo.ver, measure height
from bottom edge of mowerto ground. Distance “A” on
both sides of mower should be the same or within 1 /4"
of each other.
•
if adjustment is necessary, make adjustment on one
side of mower only.
•
To raise one side of mower,
tighten
lift link adjustment
nut on
that side.
•
To lower one side of
mower,
loosen lift link adjustment
nut on that side.
NOTE; Three full turns of adjustment nut will change
mower height about 1/8“.
•
Recheck measurements after adjusting.
FIG. 19
FIG. 20
IMPORTANT: DECK
THE FOLLOWING F
NECESSARY. BESU
rO ADJl
IK ADJUSTMENT if
'BOTH FRONT LJNKi
er he
I,, -
3inq
To obtain the
best cutting results,
the
n
should be adjusted so that trie front is appro
1 A io-xf. t-efi u! m.r rtfi-n •.! I w w r - i i m > ( - higiiesl
position.
Check adjustment on right side of tfdcior. Measure dis
tance “D” directly in front and behind the mandre! at bottom
edge of mower housing as shown.
® Before making any necessary adjustments, check that
both front links are equal in length. Both links should be
approximately 10-3/8".
•
if links are not equal in length, adjust one link to same
length as other link.
•
To lower front of mower loosen nut “E” on both front
links an equal number of turns.
•
When distance “D” is 1/8" to 1/2" lower at front than
rear, tighten nuts “F” against trunnion on both front
links.
•
To raise front of mower, loosen nut “F” from trunnion on
both front links. Tighten nut “E” on both front links an
equal number of turns.
•
When distance “D” is 1/8” to 1/2“ lower at front than
rear, tighten nut “F” against trunnion on both front links.
FIG. 21
BOTH FRONT LINKS MUST BE EQUAL IN LENGTH
21
FIG. 22