NordicTrack NTEL05900 - Manual (Page 5)

ASSEMBLY
Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two
included alien wrenches, assembly requires a phillips screwdriver
, an adjustabie
wrench , a rubber mallet,------------------ 1 | 'j , and pliers
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
page 14. The second number refers to the quantity used in assembly. Note: Some small parts may have been
pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
- ■ MS Split "..
M10 Nylon Locknut (26)-7 Washer (58)“2 Washer {33)-2
Front Stabilizer Bolt (86)-2
Chrome Tube Plastic Pedal
Washer (84)-2 Spacer (92)-2
læwiMiiiâ.
.................
M10x85mm Bolt (25H
Rear Stabilizer Bolt (60)-2
Pedal Screw (43)“6
Incline Axle Screw (30)-2
1. Identify the Rear Stabilizer (94), which has Wheels (45)
attached to it.
Attach the Rear Stabilizer (94) to the rear of the Frame
(1) with the two Rear Stabilizer Bolts (60) and two M10
Nylon Locknuts (26). Make sure that the Rear
Stabilizer is turned so the Wheels are not touching
the floor.
2. Attach the Front Stabilizer (90) to the front of the
Frame (1) with the two Front Stabilizer Bolts (86) and
two M10 Nylon Locknuts (26).