MTD 315-860-000 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
15.
Place the shift rod through the slot in the bot
tom frame cover. Thread rod into ferrule. See
■figure 10.
FIGURE 10.
16. Move the shifting rod up or down until the
------- drive clutch bracket shows in the locating
slot. See figures 10 and 11.
FIGURE 11.
17.----- Place the shift lever in neutral (N) position.
Screw the shift rod in or out until it fits into
the hole in the shift lever (drive clutch must
still be showing in the locating slot). When
shift rod is adjusted to the correct length, in
sert the end into the hole in the shift lever.
Secure with hairpin cotter (K) as shown in
-------figure 12.
FIGURE 12.