Blade – MTD 113-080A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Brake
Cable
Slot
Upper Hole
on Bottom of
Housing
Place the end of the brake cable Into the up
per hole on the bottom of the throttle control
housing, and through the slot as shown in
-figure 6. Be careful not to bend or kink the
cable.
■1^ NOTE
The control cable should be as
sembled under the lower handle.
Blade-
Control
Handle
“Z” End of-'
Brake Cable
//
Snap the end of the cable into the throttle con
trol housing. Hook the “Z” end of the brake
-cable into blade control handle. See figure 7.
FIGURE 7.
End of
Brake
Cable
NOTE
It may be necessary to push the end
of the brake cable using a screw-
■driver as shown in figure 8 to allow
enough slack for the cable to be as
sembled to the blade control handle.
FIGURE 8.