Off-season storage – MTD 219-405-000 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE
Upon reassembly, refer to illustra
tion on page 18 for correct assembly
of wire belt guard for your model
tiller.
Hub
FIGURE 26.
NOTE
If the “V”-idler or flat idler pulleys
are removed for any reason, be sure
to install with hub side against the
idler bracket. See figure 26.
OFF-SEASON STORAGE
If the tiller will not be used for a period longer than 30
days, the following steps should be taken to prepare
the tiller for storage.
1. Clean the exterior of engine and the entire tiller
thoroughly. Lubricate the tiller as described in the
lubrication instructions.
2. Refer to the engine manual for correct engine
storage instructions.
3. Wipe tines with oiled rag to prevent rust.
4. Store tiller in a clean, dry area.
NOTE
When storing any type of power
equipment in an unventilated or
metal storage shed, care should be
taken to rustproof the equipment.
Using a light oil or silicone, coat the
equipment, especially any springs,
bearings and cables.
13