Troy-Bilt 12069-7HP - Manual (Page 65)

^ 1 1 ^ Cl
Iiwâ
TILLER SPECIFICATIONS
Height —
(Approximate minimum heights)
Handlebars in lowest setting: 37X" *
Handlebars in highest setting: 49‘^' *
Without Handlebars: 33W **
* Tines resting on ground.
** Measured from knob on Wheels/Tines/
PTO Drive Lever to the ground.
Length —
(Approximate minimum lengths)
With Handlebars: 60”
Without Handlebars: 5614”
Width —
Hood width: 2214"
Tilling width: 20"
Weight —
(Approximate weight of assembled tiller
including motor oil in engine, but exclud­
ing gasoline in fuel tank and weight of
shipping container)
7HDP Recoil Start Model: 284 lbs. *
7HP Electric Start Model: 310 lbs. *
8HP Recoil Start Model: 296 lbs. *
8HP Electric Start Model: 324 lbs. *
Transmission —
Consists of two separate trans­
missions, the Power Unit transmis­
sion and the Tine Attachment
transmission. Both transmissions
are encased in cast iron housings
and operate in separate baths of
gear oil. The housings are se­
curely connected by a locking col­
lar, a dowel pin, and two large
swing-bolts. By loosening the
swing-bolts, the Power Unit can be
disconnected from the Tine
Attachment and used as a separate
power source for optional powered
and non-powered PTO attachments.
Transmission Gear Oil —
Small Top-Offs: use SAE 140,
SAE 85W-140, or SAE 80W-90.
Must have an API rating of GL-3,
GL-4 or GL-5.
Full Replacement: use SAE 140
or SAE 85W-140 with an API rat­
ing of GL-4 only.
Power Unit Gear Oil Capacity:
approximately 60 ounces. Impor­
tant- use the oil level check hole
as your final guide for gear oil
level correctness.
Tine Attachment Gear Oil
Capacity: approximately I 2 V 2
ounces, but use the transmission
dipstick as the final guide.
Transmission Gear Oil
Capacity —
PTO Power Unit: 60 ozs (approx.)
Tine Attachment: I 2 V 2 ozs (ap­
prox.)
Wheels —
One-piece steel; 8" in diameter.
Tires —
7HP Model and 8HP Model are
equipped with 4:80 x 8" bar tread
tires.
Recommended air pressure is
lO-to-20 pounds/square inch.
Engine Specifications —
Please see the engine manufac­
turer literature supplied with your
tiller for complete specifications
and details regarding the engine.
Wheel And Tine Speeds
At 3000 RPM (revolutions per minute) engine speed, the wheel and tine speeds are as follows:
BELT
POSITION
WHEEL SPEED
LEVER POSITION
WHEEL
SPEED
TINE
SPEED
Low Range Slow .5 MPH 146 RPM
Low Range Fast 1.2 MPH 146 RPM
High Range Slow .7 MPH 200 RPM
High Range Fast 1.72 MPH 200 RPM
65