MTD 191-768 User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS FOR MODEL 190-768 AND 191-768 SNOW BLOWER
1.
Remove bag of parts, elbow assembly and
control rods.
2. Remove cardboard inserts.
3.
Remove snow thrower. Be sure that every
thing is out of the carton before discarding
the carton.
4. Remove cutting unit from tractor.
A.
Remove cotter pin and outside linkage
arm from tractor.
B. Remove cotter pin and Inside linkage
arm from tractor.
C. Remove cotter pin and Lift lever bracket
from tractor.
D. Disconnect Drive shaft at the P.T.O.
and remove.
E. Slide cutting unit out.
5.
Remove front hanger bracket from snow
thrower by removing the clevis pin and
cotter hairpin.
6. Attach hanger bracket to tractor with four 5/16
bolts and sems nuts provided. See Fig. 3.
7.
Attach snow thrower to mounting brackets
with clevis pins and cotter hairpin. See Fig. 2.
8.
Remove battery ground wire from Left Hand
side plate. Attach clutch support bracket to
side plate and replace battery ground wire
and bolt.
9.
Attach clutch rod to clutch engagement lever
with 5/16 X 7/8 bolt.
10.
Attach stack control rod In eye bolt. Attach
clip to control rod and attach clip to clutch
support bracket with clevis pin and cotter
hairpin.