Poulan 157469 - Manual (Page 6)

г
";ош пе # trsd'jf has ueer^ asst.-mbled a! ibe factory with exception of ihose parts left unasscimbfcd for shipping pu'poses
Tc> efit...ji-t t S t e '?nri piopsr apeialion t'f y-oijr Iracrcr all pafis an-i Г18Г(1эдд-<= y « j o as'scriibl'; 'пур he (¡рР|ег!ео сесь'»а1г' 1 <st-
ti'ie coirecf t''4)i-; a;- r-etessary fo insue proper tjcihtnea:-:
И/Я ЧЯИ -
A socket wrencl-, S6i #ili make assembly easier Standard
wrench sizes are listed.
(1) 3/4” Socket w/driv'e rached Utility knife
(2) 7/16“ wrenches Tire pressure gauge
(2) 1/2“ wrenches
(1) 9/16" wrench
When right or left hand is rrieiitioned in ihis rranual, it
means when you are in the operating position (seated
bohirid the ofeering whee').
TO REMO¥E TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton (See page 5).
• Cut, from top to bottom, along lines on all four corners
of carton, and lay panels flat.
• Check for any additional loose parts or cartons and
remove.
BEFORE ROLLING TRACTOR OFF SKID
ATTACH STEERING WHEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
• Slide extension shaft onto lower steering shaft. Align
mounting holes in extension and lower shafts and
install 5/16 hex bolt and locknut. Tighten securely.
IMPORTANT: TIGHTEN BOLT AND NUT SECURELY TO
18-22 FT. LBS TORQUE.
• Place tabs of steering boot over tab slots in dash and
push down to secure.
INSTALL STEERING WHEEL
• Position front wheels of the tractor so they are pointing
straight forward.
• Slide steering wheel adapter onto steering shaft exten­
sion.
• pnbrti^^n nnyi wt f el =’i-i iPP r-^L'-embX - I ' , ' V
baft are horizontal rigntjand 'iidp onto adapter
• A^scmblp l-^ige tie \w sfh • US lock wa>^hpr *’/8 h-
tolt -''•fj tignh ti if "uiflj
• Snap steering wheel insert into center of steering
wheel.
• Remove protective plastic from tractor hood and grill.
IMPORTANT; CHECK FOR AND REMOVE ANY STAPLES
IN SKID
THAT MAY PUNCTURE TIRES WHERE TRACTOR
!S TO ROLL OFF SKID.
TO ROLL TRACTOR OFF SKID (See Opera­
tion section for location and function of con­
trols)
• Press lift lever plunger and raise attachment lift lever to
its highest position.
• Release parking brake by depressing clutch/brake
pedal.
• Place Leewheel coniiol n freev^heeiing position to
di'enyrng* tnnrnis^ion *10 TP^NSPCRT" in
the Opeiaftan section a» tni* mctnuai).
• Rt'li irauoi back warn o oft J'ld
• Remove hsriding holding diorherge guard up against
tractor.