Ahaching the stabilizer, Ahaching the rear height adjustors, Ahaching the rear wheels – MTD 110A508R000 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1/4-20 Hex Hut
AHACHING THE STABILIZER
1.
Attach stabilizer to rear brackets with 1/4-20 x 5,,
hex bolts, 1/4" split washers and 1/4-20 hex nuts.
See figure 8A. Assemble both sides loosely then
tighten securely.
AHACHING THE REAR HEIGHT ADJUSTORS
1.
Attach the rear height adjustors to the angled holes
in brackets as shown. See figure 8B. Secure with
3/8-16 hex keps nuts.
NOTE: The adjustors are different - assemble so axle pin
on adjustor is toward rear of mower on both sides as shown.
2.
Assemble plastic knobs to wheel height adjustor
levers by pressing on or tapping lightly.
FIGURE 8B.
1/2" Flatwasher
AHACHING THE REAR WHEELS
1.
Attach rearwheels to adjusters with 1/2" flatwashers
and cotter pins. See figure 9. Bend ends of cotter
pins to secure.