Poulan PRO 305 - Manual (Page 4)

WARNINGS AND SAFETY INSITIUCTIONS (continued)
A WARNING
Because a chaiu saw is a higb-sj^d wood-cuttiug tool, special safety precau­
tions must be observed to reduce the risk of accidents. Careless or improper use
of this tool can cause serious ipjuiy^
Hearing
Protection
Snug
Fitting
Ciiothing
Safety
Shoes
Safety Hat
Eye Protection
Heavy Duty Gloves
Figure 4
KNOWypUKSAW
1. Read your operator's manual carefully until
you completely understand and can follow all safety
rules, precautions, and operating instructions before
attempting to operate the unit.
Restrict the use of your saw to adult users who
imderstand and can follow safety rules, precautions,
and operating instructions fouhd in this manu;^.
2 .
PIANAHEIAD
1 . Wear protective gear. Figure 4 v Always use
steel-toed safety footwear with non-slip soles; sni^-
fitting cIothing;beavy-duty, non-slip gloves; eye pro-
tiecripn such as imn-fogging, vented ga^es or fac^
screen; an approved safety hard hat; andsound ba^^
riers-^-^ear plugs or mufflers to protc^ your hearing.
Regular users shpuld have bealuig cheijied regularfy
as chain saw noise can damUge hearing
2. Kebp childreih bystanders, and animsds a
minimum of 30 feet (10 Meters) away fromthe
work sp^a. Dp npt allow other people or animals to
he heah^e chain saw when souring or operaringthe
chainsaw.
3. Do not^ handde or operate a chaiu saw when
you are fatigued^ iHt oi* bpeet, pr if yOU aro un^
der the ixiiluence of alcohol, d^
tion. You must be in good physical con<htion mid
mentally aleri. Chain saw work is strenuous. If you
have^^^ a^
that ndght he agi^^
strenuous work, check with your doctorhefoie oper­
ating a chain saw.
4. Do not attempt to use your chain saw during
bad weather conditions such as strong wind, rain,
snow, ice, etc., or at night.
5. Carefully plan your sawing operation in ad­
vance. Do not start cutting tmtif you have a clear
work area, secure footing, and, if you are fellingtrees,
a planned retreat path.
AVOID REACTIVE FORCES
Pinch-Kickback and Pull-In occur when the chain
is suddenly stopped by beingpinched, caught, or by
contacting a foreign object m the wood. This sudden
stopping of the chain results in a reversal of the (bain force
usea to cut wood and causes the saw to move in the opposite
direction of the chain rotation. Pinch-Kickbaek drives
the saw straight hack toward the operator. Pull-In pulls
the saw away from the operator. Either reaction can result
in loss of control and possibly serious injury.
To avoid Pinch-Kickback;
1. Be extremely aware of situations or obstruc­
tions that can cause material to pinch the top of or
otherwise stop the chain.
2. Do not cut more than one log at a time.
3. Do not twist the saw as the bar is withdrawn from
an under-cut when bucking.
To avoid Pull-In;
1. Always begin cutting with the engine at full
throttle and the saw housing against wood.
2. Use wedges made of plastic or wood, (never of
metal) to hold the cut open.
HANDLE FUEL WITH CAUTION
1
.
2 .
3.
4.
6.
6.
7.
Eliminate all sources of sparks or flame in the
areas where fuel is mixe^ poured, or stored.
There should he no smoking, open flames, or work
that could cause sparks. Allow engine to cool before
refueling.
Mix and pour fuel in an outdoor area on bare
ground; store fuel in a cool, diy, well ventilated place*
and use an approved, marked container for ail fuel
purposes.
Wipe up all fuel spills before starting saw.
Move at least 10 feet (3 meters) from the liiel-
ingsite before stmi;ingthe engine.
Do not smoke while handling fliel or while op­
erating the saw.
Tiirn the engine off and let your saw cool in a
non--combustible area^ not on diy leaves, styaw,
paper, etc. Slowly remove fuel cap and refuel unit.
Store the unit and fuel in an arm where fuel vapors
cannot reach sparks or open flames from water heat­
ers, electric motors or switches, furnaces, etc.
If situations occur which are not covered in thismanual, use ettre and good judgment* Contact your Service
¿eater if " '
4