MTD 114-074-000 - Manual (Page 13)

12. Slide the blade brake/clutch cable through the
hole in the deck as you lift off the engine and
blade brake/clutch. Be careful not to kink con­
trol cable.
13. Remove blade brake/clutch from engine
crankshaft.
Blade Brake/Clutch Installation
1. Place the new blade brake/clutch on engine
crankshaft. Line up holes on blade
brake/clutch with mounting holes on engine.
2. Place the two belleville washers onto
crankshaft. Cupped side of washers must be
against the blade brake/clutch. Secure with
hex bolt finger tight only.
3. Place cable through engine mounting hole on
deck.
4. Reverse steps 1 through 12 of preceding sec­
tion for reassembly.
OFF-SEASON STORAGE
The following steps should be taken to prepare
lawn mower for storage.
1. Clean and lubricate mower thoroughly as
described in the lubrication instructions.
2. Refer to engine manual for correct engine
storage instructions.
3. Coat mower’s cutting blade with chassis
grease to prevent rusting.
4. Store mower in a dry, clean area.
A
CAUTION
When storing any type of power
equipment in an unventiiated or
metal storage shed, care should be
taken to rust proof the equipment.
Using a light oil or silicone, coat the
equipment, especially the bearings
and cables.
HANDLE STORAGE
The handle can be stored in an upright position to
take less space. Move hairpin cotters to outer hole
on weld pins (see figure 2). Grasp the lower handle
at the bottom and push inward slightly. Tip the
handle forward. It will lock in this position.
Reverse this procedure to place the handle in the
operating position.
A
CAUTION
Be careful not to kink or pinch blade
brake/clutch cable when storing the
handle.
13