To adjust brake (see fig. 26), To replace motion drive belt (see fig. 27), Transmission removaureplacement – Poulan 160886 User Manual
Page 21: Service and adjustments, Front wheel toejn/camber
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
TO ADJUST BRAKE (See Fig. 26)
.)< M..
I
I (II,, , H ii, '1 if- I
teif»
which is mounted on the side of the transaxle.
if I F » ' »»l| - ' ilif r (S-if =1» !fi, ’'r >=t <^u.s f rr It ’ <r !-
< .• tliuh'^st
r-'f, I .
i>< ,<
I- J
Pt.p::-CiCK >ch c aк-''pt'1alv.íldг■^'г..¡eu...l^
*
„f,-c hi-'•<e._r t ,-r^
, - -.ft i r - » , l ' F i "
nuf ‘A' -•ri Diake rod
'
¡1 ciictdF Lt l i . t h e ' t h d i ' 1 1 ' i i j ' o - n e i a n d t u i n
nut A' ijptil ciJani = Leccrtie^ 1-1/_‘. Sctiyhten ¡an
not aga'p''^ nut' A’
•
Road test tractorfor proper stopping distance as stated
above. Readjust if necessaiy. If stopping distance is
still greater than six (6) feet in highest gear, further
maintenance is necessary. Contact your nearest au
thorized service center/department.
WITH PARKING BRAKE “ENGAGED"
DO NOT TOUCH THIS NUT. IF FURTHER BRAKE ADJUST
MENT IS NECESSARY CONTACT YOUR NEAREST AUTHO
RIZED SERVICE CENTER/DEPARTMENT
FIG. 26
TO REPLACE MOTION DRIVE BELT
(See Fig. 27)
Park the tractor on level surface. Engage parking brake.
For assistance, there is a belt instailation guide decal on
bottom side of left footrest.
» Remove mower (See “TO REMOVE MOWER” in this
section of this manual.)
•
Remove upper belt keeper.
•
Remove belt from stationary idler and clutching idler.
•
Pull belt slack toward rear of tractor. Carefully remove
belt upwards from transmission input pulley and over
cooling fan blades.
•
Pull belt toward front of tractor and remove downward
from around engine pulley.
•
Install new belt by reversing above procedure.
IMPORTANT:
MAKE SURE UPPER BELT KEEPER IS
POSITIONED PROPERLY BETWEEN LOCATOR TABS.
TRANSMISSION REMOVAUREPLACEMENT
Should your transmission require removal for service or
replacement, it should be purged after reinstallation and
before operating the tractor. See “PURGE TRANSMIS
SION” in the Operation section of this manual.
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOEJN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
21