Handle — pane assem )ly, Figure 1, Assembly – MTD 214-381-000 User Manual
Page 4: Instructions, Note, Tools required, Loose parts in carton: (see figure 1), Contents of hardware pack: (see figure 2), Tailpiece installation, Assembly instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
a
•m
P
Tailpiece
Handle
— Pane
Assem )ly
Control
-Rod
De )th
B ir
FIGURE 1.
f:) £ I
M-
K-*-0l=:3)
't
FIGURE 2.
“U” Clevis
Pin (A)
Frame
Tailpiece
Cotter Pin (B)
FIGURE 3.
ASSEMBLY
INSTRUCTIONS
NOTE
This unit is shipped WiTHOUT GAS-
OLiNE or OiL. After assembiy, see
separate engine manuai for proper
fuei and engine oii recommenda
tions.
Before any step is undertaken, the instructions for
that step shouid be read thoroughiy.
Tools Required:
(2) 9/16" Sockets, open or box wrench
-Loose Parts in Carton: (See Figure 1)
Handle Panel Assembly
Depth Bar
Ta.lpiece
Control Rod
Hardware Pack (Not Shown)
-Contents of Hardware Pack: (See Figure 2)
A
B
C
D
E
F
G
H
I
K
L
M (2)
N (2)
O (2)
P
Q
(1) “U”-Clevis Pin .50" Dia.
(1) Internal Cotter Pin
(2) Cable Ties
(2) Hex Bolts 3/8-16 x 1.00" Lg.
(2) Belleville Washers 3/8" I.D.
(2) Lock Washers 3/8" I.D.
(2) Hex Nuts 3/8-16 Thd.
(1) Ferrule
(2) Hairpin Cotters
(1) Clevis Pin
(1) Spring Pin
Carriage Bolts
Lock Washers 5/16" I.D.
Hex Nuts 5/16-18 Thd.
(2) Clevis Pins (385 Only—Not Shown)
(2) Cotter Pins (385 Only—Not Shown)
TAILPIECE INSTALLATION
Slide the tailpiece into the frame. Secure with
-“U”-clevis pin (A) and cotter pin (B). See figure 3.