VeriFone Vx570 - Manual (Page 7)

POS Start Guide
Jan 2013 6 VeriFone Vx570
Vx570 Installation Instructions
These instructions will assist with the setup of the VeriFone Vx570 terminal. Select a
location that has access to a power outlet and a telephone line for your terminal.
Note: Digital Telephone lines are not compatible with any Medicaid POS terminals. Please
consult with your Telecommunications Department, Office Manager or Telephone
Company if you have any questions regarding your telephone service.
Quick Start
The Quick Start is an easy way to setup up the VeriFone Vx570 terminal.
1. Select a location that has access to a power outlet and a telephone line for your
terminal. Open the box and unpack the terminal.
2. Connect the telephone line cable into the telephone jack labeled with an image of a
telephone in the back of the terminal. Connect the other end into the wall jack.
3. Connect the power connector into the power port on the side of the terminal, and the
power cable into the power pack. Plug the three-prong power cable into the power
outlet.
4. After the device has gone through its start-up routine, the day, date, and time is
displayed on the top line of the terminal.
5. Enter your National Provider Identifier(s) (NPI) or MMIS Identification Number(s) (A
typical providers only). Refer to the section on Instructions for Provider Menu (P2 key) of
this manual.
6. If you are required to dial a number to get an outside line (e.g. ‘9’), Refer to the section
on Instructions for Setup Menu (P1 key) of this manual.
7. Press the F4 key or swipe the Medicaid ID card in the Magnetic Card Reader to begin
processing transactions to eMedNY.