Pentair EasyTouch EZ3400 - Manual (Page 5)

Rev. C 10-31-02 5 P/N 520044
SECTION IX. CUSTOMIZING THE COMMUNICATION LINK
The communication link between the Receiver and Hand-held Remote can be customized to prevent electrical
interference. To accomplish this, there is a 10-position configuration switch located on the Receiver circuit board,
and inside the Hand-held Remote. Units are shipped from the factory with all switches in the ON position.
If you wish to change this setting, use a paper clip or other blunt instrument and adjust both 10-position
configuration switches to matching settings. If the configuration switch setting at the Receiver does not match that of
the Hand-held Remote the communication link will not function.
Labels have been provided, marked with the most commonly used functions. These labels may be affixed to
the side of the Hand-held Remote to assist with button identification.
SECTION X. HAND-HELD REMOTE BATTERY REPLACEMENT
With normal use the battery should last for several years. In the event the battery must be replaced, slide the cover
from the bottom of the Hand-held Remote. Slide the battery from the retainer clip and discard in accordance with
local and/or state ordinances. Replace with 3V lithium battery number CR2032 or equivalent. Slide battery cover
onto remote and snap in place.
Receiver Hand-held Remote
Switch
NOTE: All Program Switches are Factory set to “ON”.
Battery
Compartment
Affix
Button
ID
Labels
Here