General information, 1] grounding instructions, 2] oven diagram – Sharp Carousel R-305KS User Manual

Page 8: Oven, Chapter 5. general information, Chapter 5. general information [1] grounding, Instructions -1, 2] oven, Diagram -1, Chapter 5

Advertising
background image

R305KS

5 – 1

R305KS

CHAPTER 5.

GENERAL INFORMATION

[1] GROUNDING INSTRUCTIONS

This oven is equipped with a three prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accor-
dance with the National Electrical Code and local codes and ordinances.

In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current.

WARNING:

Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 120 volt 60 Hz, AC only, 15 or 20 amp. fused electrical supply. It
is recommended that a separate circuit serving only this appliance be provided. When installing
this appliance, observe all applicable codes and ordinances. A short power-supply cord is provided
to reduce risks of becoming entangled in or tripping over a longer cord. Where a two-pronged wall-
receptacle is encountered, it is the personal responsibility and obligation of the customer to contact
a qualified electrician and have it replaced with a properly grounded three-pronged wall receptacle
or have a grounding adapter properly grounded and polarized. If the extension cord must be used,
it should be a 3-wire, 15 amp. or higher rated cord. Do not drape over a countertop or table where
it can be pulled on by children or tripped over accidentally.

CAUTION: DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE ROUND

GROUNDING PRONG FROM THIS PLUG.

[2] OVEN DIAGRAM

1. OVEN

1. Door opening button

Push to open door.

2. Oven door with see-through win-

dow

3. Safety door latches

The oven will not operate unless
the door is securely closed.

4. Door hinges

5. Door seals and sealing surfaces

6. Turntable motor shaft

7. Removable turntable support

Carefully place the turntable sup-
port in the center of the oven floor.

8. Removable turntable

Place the turntable securely on the turntable support securely. The turntable will rotate clockwise or counterclockwise. Only remove for cleaning.

9. Ventilation openings (Rear)

10.Oven light

It will light when oven is operating or when the door is open.

11. Waveguide cover: DO NOT REMOVE.

12.Auto-Touch control panel

13.Time display: 99 minutes, 99 seconds

14.Power supply cord

3-Pronged
Plug

Grounded
Receptacle Box

Grounding Pin

3-Pronged Receptacle

14

8

9

7

12

13

1

5

3

4

2

6

11

3

10

Advertising