Mounting controller to wall, Ab c d – Hunter SRC User Manual

Page 8

Advertising
background image

4

5

MOUNTING CONTROLLER TO WALL...................................................................................

A

B

C

D

NOTE: The SRC is not water or weather resistant.

The controller must me installed indoors or in a

protected area. If outdoor installation is desired,

the MPC (an optional outdoor mounting enclosure)

is available.

1. Select a location as close as possible to a standard electrical outlet,

one that is not controlled by a light switch. The location should be

protected from moisture and direct sunlight.

2. Remove the mounting bracket (A) from the back of the controller

housing by pulling the bracket down and slightly away from

the unit.

3. Place the mounting bracket slightly below eye level. Using the hole

at the top and the slide cutout at the bottom, secure the bracket with

the 1" (25mm) screws (B) provided. Note: Install screw anchors if

attaching mounting bracket to drywall or masonry.

4. Align slotted openings on back of controller housing (C) with rails

on the mounting bracket (D). Gently slide the controller down into

position on the bracket.

5. Secure controller in place by installing a screw through the lower

central mounting hole.

Do not plug transformer into power source until

the controller is mounted and all valves have

been connected.

Advertising