Cardo Systems SCALARIDER Q2 - Manual (Page 8)

sure to clean the selected area prior to the gluing process).
4. Use the pre-moistened Towelette to clean the helmet area where
you want to install the Glue Plate. Allow to dry thoroughly.
5. Peel the foil cover from the Glue Plates’ adhesive pad.
6. Place the Glue Plate into position according to #3. Press firmly 15
seconds on all 3 parts of the Glue Plate.
7. The adhesive pad bonds to full strength over the next 24 hours.
Therefore it is recommended to not use the headset during this 24
hour period.
8. Fasten the Clamp to the Glue Plate using the Allen screws that were
previously removed.
If you have purchased a helmet clamp version with the corded
microphone, please proceed as follows:
ATTACHING THE CORDED MICROPHONE CLAMP ON A
FULL-FACED HELMET
If you are using the corded microphone version, you must first make
sure your helmet clamp is attached to your
helmet as described in previous section
(ATTACHING THE CLAMP ON THE HELMET).
Clean the exact spot on the internal padding of
the helmet, opposite your mouth, where the
microphone will be placed and proceed as
follows.
a. Peel the foil cover from the adhesive Velcro
pad and place the Velcro pad on the chosen
location opposite your mouth.
b. Attach the microphone to the Velcro, as shown
in photo.
c. When done, tighten the screws of the clamp
POSITIONING THE SPEAKERS
Speaker A
Speaker B
Attach the speakers to the Velcro inside
your helmet opposite your ears (short
speaker cord for the left ear [A] and the
long speaker cord [B] for the right ear). You
may want to use the supplied Velcro pad.
Speaker A
Speaker B
Speaker B
Cable
Using two speakers inside the helmet
may be prohibited in certain
jurisdictions. If this is the case,
you should tuck away the long
corded speaker underneath the
helmet padding as follows:
Lead the speaker cord [B] along-
side the rim of the padding to
the right side and then back
to the left side, near speaker
[A]. Then place the speaker [B]
underneath the padding.
ATTACHING AND REMOVING THE
HEADSET FROM THE HELMET CLAMP
ATTACHING:
Slide the headset downwards along the
sliding panel until a clicking sound indi-
cates that the headset is locked in place.
8 scala rider ® Q2 ™ MultiSet