Operating conditions for the united kingdom, Electromagnetic compatibility – Cisco 1800 User Manual
Page 4
4
Regulatory Compliance and Safety Information for Cisco 1800 Integrated Services Routers (Fixed)
OL-10256-02
Electromagnetic Compatibility
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Operating Conditions for Australia and the European Community
The warnings and safety guidelines listed in the section
“Translated Safety Warnings” section on page 13
in this document apply to routers used in Australia and the European Community.
Operating Conditions for the United Kingdom
In addition to the warnings and safety guidelines listed in the section
in this document, the following warnings and safety guidelines apply to routers used
in the United Kingdom:
•
The router is designed to meet the requirements of interim CTR3 for Basic Rate Access.
•
Interconnection directly, or by way of other apparatus, of ports marked:
“Safety Warning—See instructions for use”
with ports marked or not so marked may produce hazardous conditions on the network, and that
advice should be obtained from a competent engineer before such a connection is made.
•
The BRI connector must be hardwired permanently to the S-reference connection point by using a
connect one-time-only, nonremovable plug (RJ-45 with the latch tab removed).
•
The ports marked “10BaseT,” “Console,” and “ISDN” have a safety warning applied to them as
follows:
“These ports do not provide isolation sufficient to satisfy the requirement of EN41003; apparatus
connected to these ports should either have been approved to EN41003 or have previously been
evaluated against B5E301 British Telecommunications plc (Post Office) Technical Guides 2 or 26
and given permission to attach; any other usage will invalidate any approval given to this apparatus.”
Other usage will invalidate any approval given to this apparatus if as a result it ceases to comply with
EN41003:1993.
•
This apparatus must be connected to a main socket outlet with a protective earth contact.
•
Connection of power supply: The router is intended for use when supplied with power from a supply
providing 100 to 240 VAC, 50 to 60 Hz, up to 0.5A.
Electromagnetic Compatibility
This section describes electromagnetic compatibility (EMC) compliance conditions for the
Cisco 1800 fixed configuration routers. It contains the following:
•
Country Approvals and Standards
•
•
•
•