Canon Printing Using a Direct Camera/Printer Connection Guide Direct Print - Manual (Page 18)

PictBridge Printing with Bubble Jet Printers
16
„ Setting the Printing Area (Trimming)
Please set [Paper Settings] first (p. 18) before setting the trimming settings. If the print
style is changed after having made trimming settings, you must select the settings
again.
1 Select [Trimming] and press the SET
button.
The trimming frame will appear at the center of the
image. If a trimming setting has already been selected
for the image, the frame will appear around the
previously selected portion.
The trimming setting screen differs depending on the camera model. Check which
of the following screens appear before selecting settings.
2a Trim the image.
Changing the Size of the Trimming Frame
z Press the zoom lever or the zoom button to adjust the size of the trimming
frame.
z The trimming frame can be changed to a minimum selection of approximately
half the displayed image or a maximum selection that is virtually the same size
as the image.
z Expanding the trimming frame beyond its maximum size cancels the trimming
setting.
z When printing an image that has been magnified using the trimming option,
the image quality may become coarser and grainier depending on the level of
magnification. If this happens, the trimming frame displays in red.
Moving the Trimming Frame
z Move the trimming frame using the multicontroller or the up, down, right and
left buttons.
Rotating the Trimming Frame
z You can rotate the trimming frame by pressing the DISP. button or the
DISPLAY button.
3a Press the SET button to close the setting menu.
Pressing the MENU button cancels the settings.
Trimming Frame
Steps 2a and 3a Steps 2b and 3b