Creda D010E - Manual (Page 23)

3. CONTROL PANEL / TRIMS / INNER DOOR PANEL & GLASS
(a) Control Panel
Regularly wipe with a clean, damp cloth and polish
with a clean, dry cloth.
(b) Trims
It is advisable to clean the trims regularly to prevent
any build up of soiling which may detract from the
appearance of the cooker. The recommended
method of cleaning is to wipe over the trims with a
clean, soft cloth wrung out in hot water, or mild non
abrasive cleaner. (If in doubt try the cleaner on a
small area of trim which is not notice able in normal
use), then after wiping with a cloth wrung out in
clear water, dry with a clean, soft cloth.
(c) Inner Door Panels & Glass
Open the door fully. The glass panel may now be
washed. Stubborn stains can be removed by using a
well soaped, fine steel wool soap pad.
4. REPLACEMENT OF THE OVEN LAMP
Open the oven door and remove the oven shelves.
Using a thick cloth, grip the lamp lens, unscrew anti-
clockwise and remove the lens.
Carefully unscrew the bulb anti-clockwise. Fit
replacement bulb (15W 300°C SES). Fit replacement
bulb and refit lens.
5. HOW TO CLEAN THE LAMP LENS
Open the oven door and remove the oven shelves.
Using a thick cloth, grip the lamp lens, unscrew anti-
clockwise and remove.
Clean with a non-abrasive cleansing cream and refit
lamp lens.
Care and Cleaning
DO NOT use scouring pads, or abrasive powder, which will
scratch the glass.
Warning: Before removing lamp lens, please ensure that
the electricity supply to the appliance is switched off and
the appliance is fully cold.
Warning: Before cleaning lamp lens, please ensure that the
electricity supply to the appliance is switched off and the
appliance is fully cold.
DO NOT use scouring pads, or abrasive powder, which will
scratch the glass lens
TRIMS
OVEN
DOOR
OVEN LAMP
23
OVEN LAMP