Remove spark plug wire v from spark plug i – Bolens 112-170-300 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
¿SSSS:-
Remove Spark Plug Wire
V From Spark Plug i^
FIGURE 8.
CHANGING BLADES
(Standard blade is available as optional equip
ment.)
An adjustable wrench is required to remove or in
stall the mulching baffle and blade on the mower.
1. Remove the hex spacer stop and lock washer
shown in figure 9. Remove the hex nut and
lock washer shown in figure 10. Remove the
mulching baffle.
■
Hex Nut and
Lock Washer
2. Remove the mulching blade by removing only
the center bolt and lock washer. A 9/16" box
wrench or an adjustable wrench is required.
Hold the blade with a rag to prevent cutting
your hand. See figure 11.
FIGURE 11.
3. Install the standard cutting blade by replacing
the center bolt and lock washer. Tighten
securely. Again, hold the blade with a rag for
safety. See figure 12.
FIGURE 10.
FIGURE 12.
4. For normal mowing, you should have removed
the items shown in figure 13. Have the stand
ard blade installed and the chute deflector
down.
To reinstall mulching blade, reverse the preceding
steps.
■1^ NOTE
Apply a little grease on crankshaft
when changing blades.