Before using your gas range, Installation requirements for your gas range, Material requirements – Avanti DG24CSS User Manual
Page 6: Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS
a
WARNING
HAVE THIS RANGE INSTALLED BY A QUALIFIED INSTALLER.
Improper
installation,
adjustment,
alteration,
services,
or
maintenance can cause injury or property damage. Consult a
qualified installer, service agency, or the gas supplier.
Before Using Your Gas Range
•
Remove the exterior and interior packing.
•
Check to be sure you have all of the parts listed below:
•
Oven Rack
■ Orifice Packet
•
Anti-tip bracket
« 4 leveling legs
■ 2 cooking grids
■ 4 caps and 4 rings in the burner assembly
-
4 burner knobs
•
1 oven knob
■ Broiler Tray
•
Clean the interior surface with lukewarm water using a soft cloth. (See “Cleaning” on
Page 13)
•
Have the installer show you the location of the ranges gas shut-off valve and how to
shut it off if necessary.
•
Have your range installed and properly grounded by a qualified installer in
accordance with the Installation Instructions.
•
Do not attempt to repair or replace any part of your range unless it is specifically
recommended in this manual.
•
Be sure your range is correctly adjusted by a qualified service technician or installer
for the type of gas (natural or UP) that is being used.
Installation Requirements for Your Gas Range
Material Requirements
•
Gas line shutoff valve .
•
1
/
2
" NPT male pipe thread for connection to pressure regulator
•
L.P. Gas resistant pipe-joint compound
•
AGA or CGA design-certified flexible metal connector (4-5 feet) or rigid gas supply line as
needed
•
Insulated pad or t/2" plywood if range is installed over carpeting.
1601 lOSE/RO