Bolens 131-410A User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 36.
6. Remove the hex lock nut from the idler pulley,
located on the left hand side of the deck. A
9/16" wrench is required. See figure 37.
NOTE
When reassembling idler pulley, the
hub side of idler pulley must go
(down) towards the idler bracket.
7. Remove the shoulder bolt and lock nut from
the deck lift shaft assembiy and deck bracket,
located on right hand side of deck. See figure
38. A
1
/
2
" wrench and 5/8" wrench are re
quired.
FIGURE 38.
8. Remove the hairpin cotter which holds the fer-
rule and deck hanger adjustment rod to the
deck bracket, located on the left hand side of
the deck. See figure 39.
FIGURE 37.
FIGURE 39.
20