ADT Security Services 6112 - Manual (Page 5)

Arming Your Security System Disarming Your Security System
Your security system can be armed in many different ways,
depending on the arming command used. Arming commands are
those commands used to arm the system. The most basic arming
command is to arm the entire system. This is accomplished by
entering your personal passcode and pressing EHT , or by
entering COMMAND 1.
There are several other arming commands to arm the system. For
example: arm only the perimeter, arm only portions of the
perimeter, etc. These arming functions and their respective
commands are described later in this guide. Remember:
Your security system is disarmed by entering your personal
passcode and pressing ENT . When your system is armed, you
must enter the premises through a designated entry door to
prevent an immediate instant alarm condition. Opening the door
starts an entry delay time and the Command Center emits a
pulsing "beep" tone to remind you to disarm the system. Enter
your personal passcode and pressing
time expires and the system will disarm.
If you enter through a wrong door or fail to disarm the system
before the entry delay expires, you will generate an immediate
ENTI before the delay
To ARM your $«curity system;
* Enter your personal pa^^code and press ENT. I
To DISARM your security system:
or
*
Enter an arming Command. | * Enter your personal passcode and press ENT.
Your system may be programmed to send a "closing" report to
the Central Station when arming.
My system sends a closing report.
a My system does not send a closing report.
Your system may be programmed to send an "opening" report to
the Central Station when disarming.
a My system sends an opening report.
□ My system does not send an opening report.
Silencing the Alarm
The alarm audible has a specific period of time that it sounds
before it automatically shuts off. If an alarm occurs and you want
to silence the siren before the time expires, simply enter your
personal passcode plus |
ENT | and the alarm will stop.
To SILENCE your security system:
• Enter your personal passcode and press ENT
for audible alarms.
or • Enter COMMAND 4 for service alerts.
NOTE: Some security systems are programmed so that the
sirens cannot be silenced until the zone is restored to a normal
(non-alarm) condition.
O My system can be silenced by entering my personal passcode.
D My system cannot be silenced unless the zone is returned to
normal.
Reporting an Alarm
O My system reports to a Central Station.
O My system does not report to a Central Station.
Your security system automatically disconnects your telephone
from its line when transmitting reports to the Central Station.
This prevents reports from being interrupted during transmission.
Once the report has beeft completed, the telephone line is restored
to normal service.
NOTE: If damage occurs to the telephone line and your
telephone service is interrupted, reports will not be transmitted to
the Central Station unless an alternate means of transmitting
signals is installed in your system.