Bolens 111-126A - Manual (Page 4)

Lower
Handle
ASSEMBLY INSTRUCTIONS
Inner
Hole
Outer
Hole
Weld Pin
ihs
FIGURE 1.
FIGURE 2.
NOTE
This unit is shipped WITHOUT GAS­
OLINE or OIL. After assembly, see
operating section of this manual for
proper fuel and engine oil recom­
mendations.
1. Extend throttle control which is attached to
the engine at the rear of the mower and place
on the floor. Be careful not to bend or kink
control wire.
2. Fasten hole in lower handle over weld pins in
handle mount brackets on deck. Secure with
— hairpin cotters in inner hole on weld pin. See
figure 1.
NOTE
There are two (2) holes in the handle
mount brackets. Place the lower
handle against the brackets and
secure with hairpin cotter in the in­
ner hole. Inner hole is for operation.
Outer hole is for storage.
NOTE
It may be necessary to pull open the
ends of the lower handle. This will
insure a tight fit when assembled in­
to handle mount brackets.
3. Assemble upper handle to lower handle.
—Secure with two carriage bolts and hex lock
nuts as shown in figure 2.
NOTE
There are two height positions for
the handle. See adjustment section.
4. Place the throttle control in position on right
side of upper handle. Secure with hex bolt and
— lock nut. See figure 3.
NOTE
Reference to right and left hand
sides of the unit is observed from
the operating position.
FIGURE 3.