Specifications, Assembly – Bolens 520 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SPECIFICATIONS
Model
225
225E
300
300E
350
350E
500
500E
520
Single-Stage
Single-Stage
Single-Stage
Single-Stage
Single-Stage
Engine
Tecumseh
2.25 HP/1.7 kW
2 cycle
Tecumseh
3.0 HP/2.2 kW
2 cycle
Tecumseh
3.5 HP/2.6 kW
4 cycle
Tecumseh
5 HP/3.7 kW
4 cycle
Tecumseh
5 HP/3.7 kW
4 cycle
Fuel Cap
2 qt./1.9 L
2 qt./1.9 L
2 qt./1.9 L
2 qt./1.9 L
2 qt./1.9 L
Cutting Width
20"/51 cm
20"/51 cm
20'751 cm
24'V61 cm
20"/51 cm
Auger
Triple-Paddle Impeller Hi Capacity Poly V Belt
Wheel Size
1.5
X
6" Rubber
(3.8
X
15.2 cm)
1.5
X
6" Rubber
(3.8
X
15.2 cm)
1.5
X
6" Rubber
(3.8
X
15.2 cm)
1.5
X
7" Rubber
(3.8
X
17.8 cm)
1.5
X
6" Rubber
(3.8
X
15.2 cm)
Approx. Weight
42 lbs./19.0 Kg
42 lbs./19.0 Kg
50 lbs./22.7 Kg
52 lbs./23.6 Kg
50 lbs./22.7 Kg
Start
MANUAL
YES
MANUAL YES
MANUAL YES
MANUAL
YES
MANUAL
Auger Clutch
Kit Available
Kit Available
Yes
Yes
Yes
Snow Discharge
3 Way Directional
Fold Down
Handles
Yes
Yes
Yes
Yes
Yes
* MANUAL START UNITS MAY ACCEPT AN ELECTRIC START KIT, CONTACT YOUR AUTHORIZED ENGINE
DEALER.
ASSEMBLY
Remove Snow Thrower from carton and
assemble as described.
1. HANDLE INSTALLATION
The snow thrower was shipped with the
handle in the folded down position. To
position handle for operation:
a. Remove hand knobs (A), Figure 4.
b. Lift handle up and position in
either of two operating positions:
HIGH position (B) or LOW position
(C). Pinched ends of upper handle (D)
must fit snugly around lower handle
(E).
c. Place handle plates (H) onto
threaded studs.
d. Retighten hand knobs.
e. if snow thrower is equipped with
an auger clutch control, (F) Figure 5,
the following must be done for proper
clutch engagement.
With auger clutch handle down, pull
cable up (to remove slack) until a solid
resistance is felt. Select the chain link
closest to open end of clutch lever hook
(G) and assemble. Release cable.
This procedure should provide proper
clutch engagement.