Arctic Air Refrigerator - Manual (Page 3)

Refer to the serial plate for correct electrical rating.
The power cord of the appliance is equipped with a
three-prong grounding plug for protection against shock
hazards, it must be plugged directly into its own
properly grounded three-prong receptacle, protected
with a 15 amp time delay fuse or circuit breaker. The
receptacle must be installed in accordance with the
local codes and ordinances. Consult a qualified
electrician. Receptacles with Ground Fault Circuit
Interrupters (GFCI) are NOT RECOMMENDED. DO
NOT USE AN EXTENSION CORD OR AN ADAPTER
PLUG.
If the voltage varies by 10 percent or more, appliance
performance may be affected. Operating the appliance
with insufficient power can damage the motor. Such
damage is not covered underthe warranty. If you suspect
your voltage is high or low, consult your power company
for testing.
To prevent the appliance from being turned off
accidentally, do not plug the unit into an outlet controlled
by a wail switch or pull cord.
DO NOT pinch, knot, or bend the power cord in any
manner.
CASTER INSTALLATION & SETUP
INSPECTION FOR DAMAGE
Inspect the underside of the cabinet and packaging for damage such as a
fork truck can cause. If hidden damage is found after uncrating,
immediately call the delivery carrier and request an inspection. Retain all
packaging and crating materials until the inspection is complete.
PARTS AND ACCESSORIES
Check to make sure that you have received the box containing all of the
components listed below.
D F
A
B
I
c
'Ta»
G
Other Precautions
• NEVER unplug the appliance by pulling on the power cord.
Always grip the plug firmly and pull straight out from the
receptacle.
• To avoid electrical shock, unplug the appliance before
cleaning.
NOTE: Turning the control to “OFF” turns off the
compressor but does not disconnect power to other
electrical components.
UNCRATING AND SET-UP
• Remove carton and all loose parts from inside of the unit.
• Carefully tip the unit onto its back with the help of an
assistant. Lay the unit gently to rest on blocks to avoid
damaging the condensate drain hose and the plastic
raceway that covers the evaporator tubing on the back of
the cabinet.
• Remove and discard the wood skid from the bottom and
the four (4) screws using a 3/8" socket wrench {see Fig.
1 ) .
• Using a large adjustable wrench, remove and discard the
two (2) black plastic leg levelers by turning it
counterclockwise (see Fig. 2).
A CASTER RAIL ( 2 ) E SWIVEL CASTER (2)
B TAPPING PLATE (2 ) F SPACER PLATE (4)
C BOLT (6) G SWIVEL CASTER W/ BRAKE (2)
D WASHER (6)
TOOLS NEEDED
You will need the following tools to assemble and install the casters to the
unit,
g , ,
3/8" AND 1/2" INCH
SOCKET WRENCH ADJUSTABLE WRENCH
OR PLIERS
i'l' '■
1/2" INCH FIXED
WRENCH
UNCRATING AND SET-UP
• Remove carton and all loose parts from inside of the unit.
• Carefully tip the unit onto its back with the help of an assistant. Lay the
unit gently to rest on blocks to avoid damaging the condensate drain
hose and the plastic raceway that covers the evaporator tubing on the
back of the cabinet.
• Remove and discard the wood skid from the bottom and the four (4)
screws using a 3/8” socket wrench (see Fig. 1 ).
• Using a large adjustable wrench, remove and discard the two (2) black
plastic leg levelers by turning it counterclockwise (see Fig. 2).
SCREWS
WOOD SKID
LEG LEVELER
Figure 2
Figure 1