Attaching the snow blade to the tractor – Bolens 198-954A User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8. Assemble the lift brackets to the push bar
assembly. See figure 5..
A. Place cotter pins (15) in cross bar and bend
ends over.
B. Place lift bracket (23) on cross bar.
NOTE
Lift brackets must face forward as
shown in figure 6.
C. Next place spacer (31), another lift bracket
(23) Flat washer (30), lockwasher (29) and
secure with hex screw (28). See figure*6.
FLAT
WASHER
(30)
LOCKWASHER
(29)
HEX SCREW
(28)
FIGURE 5
FIGURE 6
Attaching the Snow
Blade to the Tractor
(SEE FIGURE 9)
1. Roll the tractor over the completely assembled
blade.
NOTE
The push bar assembly may rub on
the bottom of the transaxle.
2. Raise the rear of push bar assembly up and secure
to rear of tractor with hex bolt, flatwasher and
hex lock nut. See figure 7.
D. Assemble lift brackets on other side in same
order.
4
FIGURE 7