Warningx – Avanti VM399W User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

> Electrical Connection

/^'WarningX

improper use of the grounded plug can result in the risk of electrical shock, if the power cord is

damaged, have it replaced by an authorized Avanti Products service center.

This freezer should be properly grounded for your safety. The power cord of this freezer is

equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electrical shock.

Do not under any circumstances cut or remove the third ground prong from the power cord

supplied.

Use of extension cords is not recommended.

This freezer requires a standard 115/120 volt, 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the freezer and not left exposed or dangling to prevent
accidental injury.

Reversing the Door Swing of Your Freezer

This freezer has the capability of either opening the door from the left or right side. The unit is

delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please follow these instructions.

NOTE:

All parts removed must be saved to do the reinstallation of the door.

Remove both screw-type leveling legs (6).
Remove the three screws (7) that hold the lower door hinge (3), save hinge for later use.
Remove door from upper pin (1), lift it and place it on a padded surface to prevent

scratching it.

Using a flat screwdriver remove right upper pin and transfer it to the same location on the
opposite side.
Remove the pin cap (2) from the left side of the upper frame of the door, and then transfer it

to the same location on the opposite side.

Insert lower hinge (3) previously saved to the lower left side of the door. Before placing this
hinge, reverse the direction of the boit-pin (5).
Set the door in place making sure the pin enters the bushing at the uncovered hole on the
upper frame of the door.

While holding the door in the closed position, secure the lower left hinge by tightening all
the screws, making sure the door is leveled with the counter top.

Advertising