To attach bag to mower, To convert mower to side discharge – Bolens 124-848L401 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO ATTACH BAG TO MOWER
1. Hold the chute door on the catcher panel open as
shown in figure 2.
2. Slide the frame of the grass catcher down into the
channels on each side of the mower. The hooks
on the frame go over the panel on the discharge
------chute. See figure 2.
To remove the grass catcher, lift the grass catcher
straight up.
TO CONVERT MOWER TO SIDE DISCHARGE
To convert your mower to a side discharge unit, pro
ceed as follows.
1. Remove the rear discharge chute assembly by
removing two wing nuts. Lift up on the two bottom
corners of the discharge chute assembly, and
slide it off the deck.
2. Attach the side chute deflector by first placing it
over the rear bolt in the side of the deck. Then
slide the notch in the top of the deflector around
the shoulder bolt on top of the deck. Slide the
notch in the side of the deflector around the front
------bolt in the side of the deck. See figure 3.
FIGURE 3.
3. Secure the front of the chute deflector to the bolt
on the side of the deck with one wing nut. See fig
ure 3. Secure the back of the chute deflector in
— the same manner. See figure 4.