Chipper-shredder vacuum, Engine, Other – Bolens 247.77763 User Manual

Page 17: Off-season storage

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OFF-SEASON STORAGE

Prepare your Craftsman chipper-shredder vacuum

for storage at the end of the season or if the unit wiii

not be used for 30 days or longer. A yeariy check-up
by your iocai Sears service center is a good way to
ensure that the unit runs properly next season.

Chipper-Shredder Vacuum

Clean the equipment thoroughiy.

Wipe equipment with an oiled rag to prevent

rust. Use a light oil or silicone to wipe.

Service the engine following instructions below.

Store unit in a clean, dry area. Do not store next
to corrosive materials such as fertilizer.

Engine

IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts such as
the carburetor, fuel filter, fuel line, or gas tank during
storage. Also, experience indicates that alcohol
blended fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads to
separation and formation of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage.

Drain the fuel tank.

Start the engine and let it run until the fuel lines
and carburetor are empty.

Drain carburetor.

Never use engine or carburetor cleaner

products in the fuel tank or permanent damage
may occur.

NOTE:

Fuel stabilizer is an acceptable alternative in

minimizing the formation of fuel gum deposits during
storage.

Add stabilizer to gasoline in fuel tank or storage
container.

Always follow the mix ratio found on stabilizer
container.

Run engine at least 10 minutes after adding

stabilizer to allow the stabilizer to reach the
carburetor.

Do not drain the gas tank and carburetor if using

fuel stabilizer. Drain all the oil from the
crankcase (this should be done after the engine

has been operated and is still warm) and refill

the crankcase with fresh oil.

If you have drained the fuel tank, protect the

inside of the engine as follows.

Remove spark plug, pour approximately 1/2

ounce (approximately one tablespoon) of engine
oil into cylinder and crank slowly to distribute oil.

Replace spark plug.

Other

Do not store gasoline from one season to

another.

Replace the gasoline can if it starts to rust. Rust

and/or dirt in the gasoline will cause problems.

Store unit in a clean, dry area. Do not store next

to corrosive materials, such as fertilizer.

NOTE:

If storing in an unventilated or metal storage

shed, be certain to rustproof the equipment by coating

with a light oil or silicone.

17

Advertising