Bolens 120-280R000 - Manual (Page 7)

AHACHING THE THROHLE CONTROL (Hardware C)
The throttle control is attached to the engine. Attach
the throttle control to the left side of upper handle as
-follows. See figure 3.
1. Route the throttle control cable above the drive
cover, and to the inside and below the lower
handle.
2. Place cable bracket against left side of upper han­
dle, lining up the hole in the bracket with the bot­
tom hole in upper handle. Place 1/4" hex bolt
through cable bracket and handle, from the inside
to the outside.
3. Place throttle control on the hex bolt (outside of
the upper handle), with the throttle lever facing up­
ward. Secure with spring washer (cupped side
against the throttle control) and hex nut.
ATTACHING THE BRAKE CABLE
1. The brake cable is attached to the engine, and has
a “Z” fitting on the loose end. Route the brake
cable above the drive cover, and to the inside and
below the lower handle. Place end of cable through
--------the hole in the bracket as shown in figure 4. Be
careful not to bend or kink the cable at any time.
Push the plastic fitting until it locks into the hole
in the bracket.
A
WARNING: Brake cable must be assem­
bled as shown for proper blade brake
operation.
2. Hook the “Z” end of the brake cable into the hole
in the blade control handle from the inside to the
outside as shown in figure 4.
ATTACHING THE DRIVE CLUTCH CONTROL CABLE
1. The drive clutch cable is attached to the drive
cover, and has a spring on one end. Hook the
spring on the end of the cable into the lower hole
--------on the drive clutch handle. See figure 5.
2. Pull down on the plastic cable casing, and slip the
control wire through the slot in the cable bracket.
Push the plastic fitting on the end of the cable cas­
ing into the cable bracket.
NOTE: If necessary, push down on the drive cover (see
figure 6) to obtain sufficient siack in the cable.