Audiovox MVDV4A - Manual (Page 32)

N. OTHERS
TROUBLE SHOOTING
If you experience the following problems
while using the unit, this troubleshooting
guide can help you.
No sound
Check if the unit is connected securely.
Make sure you operate the TV/monitor or
amplifier correctly.
Make sure the amplifier is set to receive
DVD signal output.
No image
** Check if the unit is connected securely.
Make sure you operate the TV/monitor
correctly.
** Make sure you set the color system
correctly.
Bad sound quality
Make sure the audio output mode is set
correctly.
Make sure the audio connection between
the unit and amplifier is right.
Disc can not be played
"" There is no disc in the unit.
Put the disc on the disc tray properly with
the label side up.
Clean the disc.
Moisture has condensed in the unit.
Remove the disc and leave the unit on for
about one hour.
"" DVD may be wrong region.
The unit doesn't operate normally
Disconnect the power plug and insert it
into the wall outlet again.
Remote control does not work
•^Remove barriers between the remote
control and the unit.
Point the remote control at the remote
control sensor of the unit.
Replace the batteries with new ones.
•§ 30 ®§